How to make the original shelf in the bathroom
Very often when repairing bathrooms and toilets it becomes necessary to close old protruding pipes. Segments of conclusions from the risers, lines of towel warmers do not add beauty to the room. One of the options for aesthetics and increased functionality is the manufacture of shelves. First, the shelves will be closed with ugly pieces of metal, and secondly, they will later serve as a storage place for all kinds of shampoos, air fresheners and detergents. For the manufacture of shelves, which is discussed in this article, the following materials are used:Pieces of plywood electric jigsaw cut into the size of the shelf. Then they are screwed to the bars. It turns out the design in the form of boxes.Then the shelf should be covered with linseed oil to improve moisture resistance and dried.It happens that the pipe also appears in one of the corners. In this case, bars are mounted on both sides in the same way. Triangle-shaped pieces of plywood are fixed at the top and bottom, and a rectangle cut into size from the end.Then the tile is laid. It is necessary to cut the pieces of tile so that they protrude over the edge of plywood by about two centimeters. The tile is easily cut with a glass cutter, but it is better to use a tile cutter if it is available.For the installation of the lower tile series, holes are drilled in each tile in the middle.Then the grooves are made recesses under the heads of the screws. Subsequently, the screws need to be covered with a grout. jpg "style =" max-width: 100%; " alt="How to make an original shelf in a bathroom">Pieces of tiles are spread with liquid nails and fixed with self-tapping screws from below. The top row fits the same, but easier, without screws. In order to close the outer cut edge of the tile, a decorative plastic corner is used. It is also glued with liquid nails. The glue should dry up about twelve hours. Then the mosaic elements are made. Since the thickness of the shelves is 70 (mm), the glass is cut slightly smaller in size, i.e. approximately 60 (mm). Glass is suitable for anyone, you can make a mosaic even from trimming.
- Pieces of plywood, suitable in size, with a thickness of 10 (mm). Moisture-resistant drywall or gypsum-fiber sheet can also be used.
- Wooden bars of 50 × 50 (mm). A metal profile of a similar size is also suitable.
- Glass of 3 or 4 (mm) thickness.
- Trimming of a tile that was left when laying the same room.
- Liquid nails,
- External decorative corners used for tiles.
- Dowels with a diameter of 6 (mm).
- Self-tapping screws 4.2 × 75 for fastening the bars to the wall.
- Self-tapping screws in size 3.5 × 25 for mounting plywood sheets to bars.
- Drying oil or wood primer
- Grout for interlacing seams.
- Glass cutter.
- Drill for tile.
- Crown in the shape of a hemisphere.
- Building level.
- Electric jigsaw or hacksaw.
- Tile cutter
- Rubber spatula.
Manufacturing processFirst two pieces of bars are fixed on both sides of the pipe using dowels and screws. The horizontal plane is controlled by the building level. It is necessary to make sure that the bars are fixed rigidly.
Date: 08.10.2018, 15:34 / Views: 62245
Christmas pack in the form of Santa Claus
How to grow avocado from a bone
How to distinguish the original alcohol from a fake. This is what you should pay attention to
Laying floor tiles
10 great styles for decorating the kitchen: which one suits you